Kapat
Arama
Flitreler

DDR3 Desktop

Görüntüleme biçimi
Sırala

8GB 2Rx8 1G x 64-Bit PC3-10600
CL9 240-Pin DIMM
Important Information: The module defined in this data sheet is one of
several configurations available under this part number. While all
configurations are compatible, the DRAM combination and/or the module
height may vary from what is described here.
DESCRIPTION
This document describes ValueRAM's 1G x 64-bit (8GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8, memory module, based on
sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC
standard latency DDR3-1333
timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact
fingers. The electrical and mechanical specifications are as follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not allow
seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB: Height 1.18” (30mm), double sided component
SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.) Refresh to Active/Refresh
260ns
(min.)
(min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.) Maximum Operating Power
2.460 W*
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.

SDSSDA-240G-G26

484,81 ₺

Sandisk SSD 

  • 1 USD = 5.6243 TRY